Mercedes-Benz Cylinder Head OEM Numbers and VADEN Equivalents

Mercedes-Benz Cylinder Head OEM Numbers and VADEN Equivalents

Mercedes-Benz Cylinder Head OEM Numbers and VADEN Equivalents

Look up the Mercedes-Benz OEM number on your cylinder head part and find the matching VADEN part: 68 Mercedes-Benz OEM numbers matched to 20 VADEN injector sleeves, pipes, gaskets, plugs and valve bridges.

Mercedes-Benz cylinder head OEM number to VADEN part number

The cylinder head closes the top of the engine and carries the valves and injectors; its gasket, plugs and injector sleeves keep combustion gases, coolant and oil apart, and valve bridges let one rocker arm open a pair of valves. Find your part's Mercedes-Benz OEM number in the tables below and follow the link to the matching VADEN part. Before ordering, confirm the match with the OEM number and the technical data on the product page; the vehicle manufacturer's service documentation is the reference.

Cylinder Head Gasket: Mercedes-Benz OEM numbers and VADEN equivalents (2)
Mercedes-Benz OEM numberVADEN part number
90401042210101 097
A90401042210101 097

Related pages

Category: Cylinder Head

All VADEN parts in this category with photos and technical data.

Go to category →
Burnt Cylinder Head Gasket: Symptoms and Causes

The symptoms of a blown cylinder head gasket, what causes it and what to check.

Read the guide →
VADEN parts for Mercedes-Benz

Mercedes-Benz models, engines and part groups covered by VADEN.

Mercedes-Benz parts →
Mercedes-Benz OEM cross reference

All Mercedes-Benz part groups with OEM number tables.

All Mercedes-Benz OEM pages →

Other Mercedes-Benz OEM cross reference pages

Air Brake Compressor Repair Kits Fan Air Compressor Water Pumps Flexible Pipe Engine Oil Cooler Master Cylinders Gearbox Housing Steering Pumps Brake Caliper Repair Kits Clutch Servo Pressure Limiting Valves Brake System: other parts Unloader Valves Air Dryer Valves Engine: other parts Engine Oil Filter Radiator Shifting Cylinders Foot Brake Valves Oil Sumps Oil Pumps Relay Valves Exhaust Manifolds Exhaust Brake Fuel Filters Flywheel Housings Air Processing Units Crankcase Brake Cylinder Split Cylinders ALB Load Sensing Valves Trailer Control Valves Cab Tilting Release Bearings Exhaust Gas Flaps Brake Master Cylinders Gearbox: other parts Release Forks Injector Pump Manual Feed Pumps Brake Caliper Carrier Brake System Connection Components Pipe ABS Sensors Engine Steering 4-Circuit Protection Valves ECAS Solenoid Valves Lever Actuators Injector Pipe Suspension: other parts Pressure Boosters Turbo Retarder Fuel System: other parts Cabin: other parts Clutch: other parts Cooling System: other parts

Frequently asked questions

How do I find the VADEN part for a Mercedes-Benz cylinder head OEM number?

Read the Mercedes-Benz OEM number on the old part or in your parts documentation, then find it in the left column of the table for that part type. The right column shows the matching VADEN part number, and the link takes you to its product page.

Should the head gasket and injector sleeves be replaced when the cylinder head is removed?

In most engines the cylinder head gasket is single-use and is replaced every time the head comes off. The injector sealing washers and O-rings are normally renewed whenever an injector is removed, while an injector sleeve is replaced if it leaks, is damaged or has been pulled out of the head. Clean and check the sealing faces before fitting, and follow the tightening sequence and values in the vehicle manufacturer's service documentation.

Are VADEN cylinder head parts original Mercedes-Benz parts?

No. VADEN parts are aftermarket replacement parts, not original Mercedes-Benz parts; the Mercedes-Benz name and OEM numbers are shown only to indicate compatibility. Confirm fitment with the OEM number and the product's technical data, and treat the vehicle manufacturer's service documentation as the reference.

Top Scroller