Volvo Cylinder Head OEM Numbers and VADEN Equivalents
Look up the Volvo OEM number on your cylinder head part and find the matching VADEN part: 36 Volvo OEM numbers matched to 20 VADEN injector sleeves, pipes, gaskets, plugs and valve bridges.
The cylinder head closes the top of the engine and carries the valves and injectors; its gasket, plugs and injector sleeves keep combustion gases, coolant and oil apart, and valve bridges let one rocker arm open a pair of valves. Find your part's Volvo OEM number in the tables below and follow the link to the matching VADEN part. Before ordering, confirm the match with the OEM number and the technical data on the product page; the vehicle manufacturer's service documentation is the reference.
All VADEN parts in this category with photos and technical data.
Go to category →The symptoms of a blown cylinder head gasket, what causes it and what to check.
Read the guide →Volvo models, engines and part groups covered by VADEN.
Volvo parts →All Volvo part groups with OEM number tables.
All Volvo OEM pages →Read the Volvo OEM number on the old part or in your parts documentation, then find it in the left column of the table for that part type. The right column shows the matching VADEN part number, and the link takes you to its product page.
In most engines the cylinder head gasket is single-use and is replaced every time the head comes off. The injector sealing washers and O-rings are normally renewed whenever an injector is removed, while an injector sleeve is replaced if it leaks, is damaged or has been pulled out of the head. Clean and check the sealing faces before fitting, and follow the tightening sequence and values in the vehicle manufacturer's service documentation.
No. VADEN parts are aftermarket replacement parts, not original Volvo parts; the Volvo name and OEM numbers are shown only to indicate compatibility. Confirm fitment with the OEM number and the product's technical data, and treat the vehicle manufacturer's service documentation as the reference.